Atec EMCP-MIG2000-6 - Manual (Page 10)

TECHNICAL SPECIFICATION E-MIG2000-6
Waveform 2/200 us
Source impedance with BT4 5 Ohms +/- 10 %
Decoupling for serial injection up to 250V at 50/60 Hz
up to 115V at 800 Hz
Repetition up to max 1 Hz
10 s(to charge the C-battery) Interval between tests
Waveform 2/400 us Using additional NW-AMD24C-400us
Source impedance with BT4 5 Ohms +/- 20 %
Decoupling for serial injection up to 250V at 50/60 Hz
up to 115V at 800 Hz
Repetition up to max 1 Hz 10 s(to charge the C-battery)
4.6 Euro Fighter Slow & Fast
NATO-SLOW-10u
Risetime < 2us
Duration 10us
±20%
Voltage range 100 V up to 850 V
Repetition up to max 10 Hz
Source impedance 5 Ohm +/- 20 %
NATO-FAST-150n
Risetime < 30ns
Duration 150ns
±20%
Voltage range 200 V up to 1600 V
Repetition up to max 10 Hz
Source impedance 50 Ohm +/- 20 %
4.7 DO160 section 17
Parallel Injection
Voltage range output 100 V up to 1200V Calibration Test tip cable length
1 m
Decoupling for parallel injection up to 250V at 50/60 Hz
up to 115V at 400 Hz
Serial Injection
Voltage range BT output 100 V up to 1200 V Calibration loop (3 turns)
Source impedance BT 50 Ohm +/- 10 %
Voltage range BT1 output 100 V up to 700 V Calibration loop (1 turns)
Source impedance BT1 25 Ohm +/- 10%
Decoupling for serial injection up to 250V at 50/60 Hz
up to 115V at 400 Hz
Repetition up to max 2 Hz
Synchronisation with box 50/60/400Hz
Angle setting 1 °
Accuracy of Synchronisation +/-5°
4.8 DO160 section 19
Spike repetition approx. 250 kHz
Burst duration approx 150 µs
Voltage 600V
Polarity reversal By turning coil
Polarity Negative and positive
Pulse Repetition max 10 Hz
0 7 . 0 5 . 2 0 0 9 E M C P A R T N E R A G 1 0 / 1 4