Atec Agilent-E4980A-AL - Manual (Page 34)

34
Display time
Except for the case of the DISPLAY BLANK page, the time required to update the display
on each page (display time) is as follows. When a screen is changed, drawing time and
switching time are added. The measurement display is updated about every 100 ms.
Table 61. Display time
When Vdc, Idc When Vdc, Idc
Item monitor is OFF monitor is ON
MEAS DISPLAY page drawing time 10 ms 13 ms
MEAS DISPLAY page (large) drawing time 10 ms 13 ms
BIN No. DISPLAY page drawing time 10 ms 13 ms
BIN COUNT DISPLAY page drawing time 10 ms 13 ms
LIST SWEEP DISPLAY page drawing time 40 ms —
Measurement display switching time 35 ms —
Measurement data transfer time
This table shows the measurement data transfer time under the following conditions.
The measurement data transfer time varies depending on measurement conditions and
computers.
Table 62. Measurement transfer time under the following conditions:
Host computer: DELL OPTIPLEX GX260 Pentium 4 2.6 GHz
Display: ON
Impedance range mode: AUTO (The overload has not been generated.)
OPEN/SHORT/LOAD compensation: OFF
Test signal voltage monitor: OFF
Table 63. Measurement data transfer time [ms]
using :FETC? command using data buffer memory
Data (one point measurement) (list sweep measurement)
transfer Comparator Comparator 10 51 128 201
Interface format ON OFF points points points points
ASCII 2 2 4 13 28 43
GPIB ASCII Long 2 2 5 15 34 53
Binary 2 2 4 10 21 32
ASCII 2 2 3 8 16 23
USB ASCII Long 2 2 4 9 19 28
Binary 2 2 3 5 9 13
ASCII 3 4 5 12 24 36
LAN ASCII Long 3 3 5 13 29 44
Binary 3 3 5 9 18 26