Atec Agilent-E4980A-AL - Manual (Page 19)

19
The following options are available for the E4980A LCR Meter.
Frequency options
None of below 20 Hz to 2 MHz
Option 030 20 Hz to 300 kHz
Option 050 20 Hz to 500 kHz
Option 100 20 Hz to 1 MHz
Interface options
Option 002 (Bias current interface)
Adds a digital interface to allow the E4980A to control the 42841A’s bias current source.
Option 201 (Handler interface)
Adds handler interface.
Option 301 (Scanner interface)
Adds scanner interface.
Option 710 (No interface)
An option with no interface.
Up to 2 interface options can be installed in the interface connector on the rear panel.
When no interface is installed, two of the option 710 are installed. When one interface
is installed, the option number of its interface and one option 710 are installed.
Other options
Option 001 (Power and DC Bias enhancement)
Increases test signal voltage and adds the variable DC bias voltage and DCR
measurement funciton.
Option 005 (Entry model)
Low-priced option that requires a longer measurement time. The level of measurement
accuracy is the same as the standard.
Option 007 (Standard model)
Upgrades the entry model to the standard.
Option 200 (DCR measurement)
Adds DCR measurement
Table 30. Installable options
Options 2 MHz 300 kHz/500 kHz/1 MHz
Power and DC bias enhancement (001) installable not installable
Bias Current Interface (002) installable not installable
Entry model (005) installable not installable
Standard model (007) installable not installable
DCR measurement (200) installable 1 not installable 2
Handler interface (201) installable installable
Scanner interface (301) installable installable
1. Mandatory option
2. DCR measurement function is equipped by default.
Note
Option 007 can be installed only in the E4980A with
option 005.
Note
Option 200, 001, 030, 050, and 100 supports DCR
measurement function.
Options
Note
Option xxx is described as E4980A-xxx in the
order information