Atec Agilent-J3763A - Manual (Page 23)

23 23 23 23 23
C C C C Co o o o on n n n nfffffigu igu igu igu igura ra ra ra ratttttio io io io ion n n n n
Depending on the interface and application the configuration lets you select
entries and options for:
- Interface/Protocols
- Decode table (protocol routing through decodes)
- Filters/Counters
- Log
- Simulate
- Full traffic generation
Auto-configuration for T1 and E1 interfaces are available.
Auto-configure T1 (physical layer)
Auto-determine:
- Line Code (AMI or B8ZS)
- Framing (ESF, D4, T1DM or Unframed)
- Receiver mode (Monitor Bridged, Monitor terminated, or Monitor Jack)
Auto-configure E1 (physical layer)
Auto-determine:
- Line Code (HDB3 or AMI)
- Framing with CRC-4, without CRC-4, or Unframed
- Receiver mode (Monitor Bridged, Monitor Terminated, or Monitor Jack)
Auto LMI in Decode Routing (link layer)
Auto LMI recognition will automatically detect the type of LMI on the Frame
Relay link.
Decoding of the correct LMI version will take place automatically for the
following standards:
- ITU-T Q.933 Annex A
- ANSI T1.617 Annex D
- Original Frame Relay Consortium (Original LMI)
The Frame Relay application will decode the Consolidated Link Layer
Management (CLLM) messages, found on DLCI 1007.
Auto Multi-protocol over Frame Relay (network layer)
The Frame Relay applications will decode the multi-protocol encapsulation over
Frame Relay automatically according to the RFC-1490, RFC-2427, Ethertype or
FRF.3.1, CLLM.