Atec Agilent-J3763A - Manual (Page 19)

19 19 19 19 19
Frame Relay UNI-Network (Switch) Emulation
The UNI-Network emulation follows the Frame Relay Forum Implementation
Agreement FRF.1.1 and ITU-T Q.933 Annex A. The UNI-Network emulation
supports the following Standards in the following order:
•ITU-T Q.933 Annex A
•ANSI T1.617 Annex D
•Original Frame Relay Consortium (Original LMI)
The UNI-Network (Switch) emulation supports the following PVC Full Status
report message setups for up to 500 different PVC-DLCIs in a table format:
•Active / Inactive PVCs
•Present / New PVCs
•Deleted / Not deleted PVCs
Frame Relay NNI Emulation
The NNI emulation follows the Frame Relay Forum Implementation
Agreement FRF.2.1 The NNI emulation supports the following Standards in
the following order:
•ITU-T Q.933 Annex A
•ANSI T1.617 Annex D
•Original Frame Relay Consortium (Original LMI)
The NNI emulation supports the following setups:
•FULL Status Polling Cycles (N391) in the range from 1 to 10 polling cycles,
with a N391 default value of 6 polling cycles.
•Status Enquiry messages (T391) counters, in the range from 1 to 60 seconds,
with a T391 default value of 10 seconds.
The NNI emulation supports the following PVC Full Status report message
setups for up to 317 different PVC-DLCIs in a table format:
•Active / Inactive PVCs
•Present / New PVCs
•Deleted / Not deleted PVCs
Frame Relay Ping
A PING test verifies whether a route exists to any given IP address.
The Advisor provides static ping measurement capabilities by sending IP-ICMP
echo requests and then waiting for the ICMP echo reply from the destination
address.
The ping tests run with LMI emulation off and on for the following options:
•UNI-User Emulation
•UNI-Network Emulation
•NNI Emulation (bi-directional polling)
The test supports the following Frame Relay Standards:
•ITU-T Q.933 Annex A
•ANSI T1.617 Annex D
•Original Frame Relay Consortium (Original LMI)