Alpha Technologies VMX Series - Manual (Page 35)

35 017-940-B0-001, Rev. A
5. Press ENTER when the desired value displays. This accesses an additional
display, giving the operator a chance to back out of the programming mode
(ESCAPE) and not save the new value. To accept and save the new value to
memory, press ENTER.
6. Once the value is entered into memory, the display returns to the Setup Menu.
You may now check and view the new value or select additional parameters to
modify.
If an incorrect value is accidently entered, repeat the above process and enter the
proper value; or select the Set Defaults menu selection on the Setup Menu and press
ENTER twice to reset all parameters to their factory default values.
5.0 Operation, continued
5.2 Smart Display, continued
5.2.3 Setup Menu
The Setup Menu is one level below the Additional Information display and is reached
by pressing ENTER. Use this menu to view and change the programmable operating
parameters of the power supply. Navigation is similar to the Normal Operation menu.
Pressing UP or DOWN accesses the Single Step mode, where sub-menu items can
be individually selected.
To select and change a value in the Setup Menu:
1. Press either UP or DOWN to put the display in the Manual Scroll mode.
2. Continue pressing UP or DOWN until the desired item displays.
3. Press ENTER to select the item for editing.
4. Use UP to increase the displayed value, or DOWN to decrease the value.
Pressing and holding either UP or DOWN for more than two seconds while in edit
mode causes the displayed value to change more rapidly.
The actual parameter being modifi ed in EDIT mode doesn’t change until the new data is saved by pressing
the ENTER key twice.
NOTE:
In addition to increasing or decreasing numerical values with UP and DOWN, the
operator can select ON or OFF and YES or NO. These are selected and entered as
described above. The PIM Option, CODE VER, VMX_CLASS VER, and Total Run
Time selections are informational display only items and cannot be edited. To return
to the “Operation Normal” menu from the Setup Menu, press ESCAPE three times.
The Set Defaults menu selection will not reset Standby Time, Standby Events, Device Address, or Total
Runtime; the operator must manually reset these settings.
NOTE: