Alpha Technologies LPE Enclosure - Manual (Page 22)

22 031-302-B0-001 Rev A
2.0 Installation, continued
2.5 Connecting the Utility Power, continued
2.5.2 Connecting Coaxial Cable
4. Insert Coaxial Termination into Output Port on bottom of SPI.
To prevent injury, DO NOT remove SPI cover until all sources of power have been
removed.
1. Verify SPI IS NOT connected to power supply.
2. Remove the two screws holding cover onto SPI chassis.
3. Remove SPI cover, exposing circuit board and seizure screw assembly.
2
3
1
Seizure Screw
Assembly
WARNING!
Coaxial Termination
Stinger
Output Port
Side View
of
SPI Case
Circuit Board
Seizure Screw
Assembly