Alpha Technologies ECM - Manual (Page 7)

7 TM 744-862-C0-003 Rev.C
Engine Control Module (ECM)
NOTE: Failure to follow these precautions could result in
injury or death caused by the explosion of fuel,
moving parts hazards or electrocution.
CAUTION: This set of procedures will require the
operation of the generator and should
only be performed by qualified,
experienced personnel in a well-ventilated area.
• Technicians must have easy access to a fire extinguisher at all
times.
• Propane/Natural Gases are highly explosive. Use extreme
caution while handling and operating the Generator gas package
and equipment. Keep flame or spark away from Propane
bottles. Do not smoke during assembly of gas package.
• Any test equipment used in the testing of the CE Series system
must have isolated inputs to prevent shock hazards and short
circuits with the enclosure or other grounded objects.
• Run Generator only in properly ventilated areas. Exhaust
gasses can be lethal. Prolonged exposure can cause nausea,
headaches, dizziness, or Carbon Monoxide poisoning.
• All pipe connections must be leak tested immediately.
• Output of upper air dam must be unobstructed.
• “Test” Propane bottles MUST not come into contact with the
cabinet(s). Use a Digital Voltmeter (DVM) to ensure proper
cabinet grounding.
• “Test” Propane bottles must remain upright at all times.
• All generator grid screens, covers, and access panels on the
generator must be closed before operation. Moving parts are a
hazard.
• Both generator compartment fans must be operational any time
gas pressure is applied.
SAFETY PRECAUTIONS