Elmo Rietschle G-BH1e - Manual (Page 15)

© Gardner Denver Deutschland GmbH 15 / 52 610.44521.40.000
Installation
4 Installation
 WARNING
Improper use of the pump−motor unit can
result in serious or even fatal injuries!
Have you read the chapter "Safety
instructions"? ( 5)
Otherwise you may not carry out any work with
or on the pump−motor unit!
 DANGER!
Danger from missing view into area of
pump−motor unit!
When operating the control elements without a
view into the area of the pump−motor unit,
there is a danger that the pump−motor unit will
be switched on while other persons are still
performing work on it. Severest injuries are
possible!
Provide control elements at a location with a
view of the pump−motor unit.
 DANGER!
Electrical danger!
The pump−motor unit must be installed so that
the electrical equipment cannot be damaged by
external influences!
In particular, the incoming cables must be
routed securely, e.g. in cable ducts, in the floor
etc.
 WARNING
Danger of balance damage caused by
vibration!
Vibrating environments can cause balance
damage!
Install the pump−motor unit on a solid
foundation or on a solid mounting surface.
Check screw glands/unions for mounting the
pump−motor unit on the mounting surface
regularly for strength and firm seating.
 WARNING
Danger of crushing due to pump−motor unit
tipping over!
Wear personal safety equipment (safety gloves
and safety shoes).
Handle the pump−motor unit with the
appropriate care.
Install the pump−motor unit on a solid
foundation or on a solid mounting surface!
Check screw glands/unions for mounting the
pump−motor unit on the mounting surface
regularly for strength.
 WARNING
Danger of fire from flammable substances!
The pump−motor unit must never come into
contact with flammable substances.
For exact information on the temperature
increase see: ( 11).
 WARNING
Danger of burns from hot surface of the
pump−motor unit and from hot media!
High temperatures of up to approx. 160 °C
[320 °F] can occur on the surface of the
pump−motor unit.
The pump−motor unit must be installed so that
accidental touch of its surface is not possible.
Cover the pump−motor unit with a suitable
touch protection (e.g. perforated plate cover or
wire cover).
 WARNING
Danger of injuries from flying parts!
Select installation so that parts that are thrown
out through the grate if the motor fan breaks
cannot hit persons!
 CAUTION
Danger of tripping and falling!
Make sure the pump−motor unit does not
present a danger of tripping.
Lay cables and pipes so that they cannot be
reached during operation (recessed in floor, in
ducts on the wall etc.).