Cla-Val 390-07/3690-07 - Manual (Page 23)

Starting Actuator Software
.
Page 4
First, be sure hardware set-up and wiring to actuator is completed. Connect laptop computer to actuator using special
multi-USB cable. Be sure computer is on and actuator is powered. Check that Actuator LED is steady green. The first
window to appear will be display.
Display
1 Start the e-Drive / CPC CLA-VAL software.
2 Select the e-Drive in the e-Line list.
3 Select language and click "Read parameters".
4 The right side will display specific configuration information. Also general information including the date of
latest calibration, the average & total working time since the first power up, the number of starts, the serial
number, the firmware version and the maximum and minimum recorded temperature is displayed.
5 Click on continuous reading to see the position of e-Drive, set point (mA) and, if used feedback position
(mA and units).
6 To manually change the setting, write the setting and click on "Override Set point".
CAUTION: Improper use of "Override Set point" may cause damage to your system