Gotham Incito DMX512_RDM Field Rev. E User Manual

Page 3

IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully

Never connect components under load.
Do not mount or support these fixtures in a manner that can cut the outer jacket or damage wire

insulation.

Unless individual product specifications deem otherwise: Never connect an LED product directly to a

dimmer packs, occupancy sensors, timing devices, or other related control devices. LED fixtures must be
powered directly off a switched circuit.

Unless individual product specifications deem otherwise: Do not restrict fixture ventilation. Allow for

some volume of airspace around fixture. Avoid covering LED fixtures with insulation, foam, or other
material that will prevent convection or conduction cooling.

Unless individual product specifications deem otherwise: Do not exceed fixtures maximum ambient

temperature.

Only use fixture in its intended location.
LED products are Polarity Sensitive. Ensure proper Polarity before installation.
Electrostatic Discharge (ESD): ESD can damage LED fixtures. Personal grounding equipment must be

worn during all installation or servicing of the unit.

Do not touch individual electrical components as this can cause ESD, shorten lamp life, or alter

performance.

CAUTION: RISK OF PRODUCT DAMAGE

CJ520003 Rev. E

3 of 11

Please see product specific installation instructions for additional warnings or any applicable FCC or other regulatory

statements.

Failure to follow any of these instructions could void product warranties. For a complete listing of product Terms and

Conditions, please visit www.acuitybrands.com.

performance.

Some components inside the fixture may not be serviceable. In the unlikely event your unit may require

service, stop using the unit immediately and contact an ABL representative for assistance.

Always read the fixtures complete installation instructions prior to installation for any additional fixture

specific warnings.