Gotham ALED Shower Trim - Manual

CJ5201020 Rev. C
5/11 1 of 2
©2010 Acuity Brands Lighting, Inc.
All Rights Reserved.
SAVE THESE INSTRUCTIONS
Upon receipt, thoroughly inspect for any
freight damage which should be brought
to the attention of the delivery carrier.
Compare the catalog description listed on
the packing slip with the label on the
carton to ensure you have received the
correct merchandise.
INSTALLATION INSTRUCTIONS
4” & 8” ALED/ALEDW & ALED
Shower Trim
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
Warning: Risk of fire. Do not install
insulation within 3 inches of fixture
sides or wiring compartment, nor above
fixture in such a manner as to entrap
heat.
Electric current can cause painful
shock or serious injury unless handled
properly. For your safety, always
remember the following:
• Turn off the supply power.
• Ground the fixture to avoid potential
electrical shocks.
• Do not handle an energized fixture or
energize any fixture with wet hands,
when standing on a wet or damp surface,
or in water
New Installation for 4” & 8” ALED/ALEDW & ALED Shower Trim
Yoke assembly for ALED/ALEDW 4” provided with mounting frame (see CJ5201006 instruction
sheet). Yoke assembly for ALED/ALEDW 8” provided with trim.
1. Pull light engine assembly included with mounting frame through ceiling opening as shown in Figure 1.
2. Remove bow spring from yoke assembly by pulling the ends of the spring through the slots in the yoke
as shown in Figure 2.
3. With the curve of the bow spring facing downward, attach it to the bracket by inserting screw located in
the bracket into the keyhole slot in the spring. Engage screw in slot and tighten securely as shown in
Figure 3.
4. Reinsert ends of bow spring into upper slots in yoke as shown in Figure 2.
5. Insert yoke assembly through ceiling opening as shown in Figure 4 and attach to mounting frame by
inserting feet into tabs as shown in Figure 5. Feet will snap into place.
6. Pull light engine assembly through ceiling opening.
7. Attach light engine assembly to top of reflector by aligning and engaging spring clips on reflector with
tabs on heat sink.
8. Push reflector into ceiling opening making sure that wallwash component is properly oriented with
respect to the wall to be illuminated as shown in Figure 6.
9. IP65 rating for ALED shower trim: Apply a bead of silicone around the perimeter of the trim in
between ceiling and outer flange edge to achieve an ingress protection rating of 65.
Figure 1 Figure 2
Figure 3 Figure 4