Extron Electronics System 4xi Series - Manual (Page 69)

Appendix B • Reference
Extron • System 4 xi Switcher Series • User’s Manual
Projector Communication Extension Cables Connectors Part #
CC 50' (50 ft.) 15/HD/M to 9/D/F 26-305-01
CC 50' Type II (50 ft.) 15/D/M to 15/D/F 26-323-01
CC 100' (100 ft.) 15/HD/M to 9/D/F 26-305-02
CC 100' Type II (100 ft.) 15/D/M to 15/D/F 26-323-02
CC 200' (200 ft.) 15/HD/M to 9/D/F 26-305-03
CC 200' Type II (200 ft.) 15/D/M to 15/D/F 26-323-03
S-Video Adapter Cables
S-VHS 6' (male-to-male, 6 feet)
26-316-02
S-VHS M20' (male-to-male, 20 feet) 26-316-01
S-VHS BNC (male-to-male, S-video to BNC, 6") 26-353-01
Connectors
Captive Screw Phoenix Connectors (6-pin, Audio)
10-163-01
Documentation
System 4
xi
User’s Manual 68-162-01
System 4
xi
Label 33-151-01
Changing the Main Fuse
_________ The Main Fuse is located on the Power Supply board. To replace the fuse,
remove the AC Power cord and remove the top cover of the System 4
xi
(procedure on page 2-3).
The picture below shows the left-rear corner of the System 4
xi
chassis. Locate
the fuse on the Power Supply board.
Remove the fuse from its holder and test it with an ohm meter or other testing
device. Replace a bad fuse with a 2 amp, 250v fuse.
If the fuse is not bad, and the unit has no indication of having power, call Extron
for instructions on service.
Figure B-2. Locate the Fuse on the Power Supply.
B-2