Extron Electronics System 4xi Series - Manual (Page 29)

Extron • System 4 xi Switcher Series • User’s Manual
Chapter 3 • Using the System 4
xi
Front Panel
3-6
Menu #7 is used to set up Demo and VGA modes.
❶
Press to get the Menu Select LCD (Menu #0).
❷
From Menu #0, press or to go to Menu #7.
❸
Press to select this menu. There are two functions in this menu as
displayed from the left selection point. They are listed in the diagram. Use to
move between the two selection points, and then use or to show the
choices, and leave
your choice displayed
before going to the
next function.
❹
From the left selection
point, press or to
choose one of the two
functions.
❺
Press to step to the
second selection point
and press
or to
change the selection. If
the display already
shows what you want,
leave it and go on.
Repeat
❹
and
❺
to
make other changes to
this menu. The choices
for this example are
circled.
❻
Press to save
these settings and
press
to go to
Menu #0. From here
you may step to
another menu and start
your next setup
procedure, or exit.
➐
Press to exit
Menu #0 and go to the
Default Menu.
_______ VGA mode is only
available on System
4LD
xi .
_______ A detailed explanation
of each menu follows,
beginning with
Menu #0 on page 3-7.
Figure 3-5. Example: Configuring the System 4 xi Line-Doubled
Output to be exactly 640 x 480, standard VGA mode
1
MENU SELECT
7.LD CFG
MENU SELECT
9.SWITCH SLAVE
MENU SELECT
8.INFORMATION
MENU SELECT
1.VID MODE CFG
MENU SELECT
3.HOST BAUDRATE
MENU SELECT
4.RGB DELAY
MENU SELECT
5.SLAVE CFG
Change Entry Point
Change Selection
Accept/Save Selection
Exit to Menu 0
MENU SELECT
0.EXIT
Default
Screen
MENU SELECT
2.AUD LEVEL CFG
Go to
Menu 0
After 2-3
second
delay
Displayed information
depends upon video
type, audio level and
breakaway setting.
Go to
Menu 9
SYSTEM 4LD NE
EXTRON V3.11
->VID 01 RGBS
->AUD 01 +00dB
Power Up
Display
MENU SELECT
6. LD SYNC CFG
7
2 3 6
4 Select function and move cursor
2 functions, 2 choices each
Make selection
LD CFG
>VGA MODE=>ON
4
4
5
5
5
a - VGA Mode:
On or Off
b - Split Screen:
On or Off
(demo mode)
*Only if configured
as a Slave switcher