Extron Electronics System 4xi Series - Manual (Page 35)

Extron • System 4 xi Switcher Series • User’s Manual
Chapter 3 • Using the System 4
xi
Front Panel
Figure 3-7. System 4 xi Display Menu Flow Chart
3-12
SWITCH SLAVE
>CHL 4= RGBS
INFORMATION
>SYS 4 LD
NE , V3.11
LD CFG
>VGA MODE =>ON
Title Menu SYSTEM 4LD NE
EXTRON V3.11
->VID 01 RGBS
->AUD 01 +00dB
MENU SELECT
0.EXIT
Default Menu
Pressing an Input Button
at any time will Exit to
Default Menu.
Change Setting
Accept/Save Setting
Exit to Menu 0
MENU SELECT
1.VID MODE CFG
MENU SELECT
2.AUD LEVEL CFG
MENU SELECT
3.HOST BAUDRATE
MENU SELECT
4.RGB DELAY
MENU SELECT
5.SLAVE CFG
MENU SELECT
6.LD SYNC CFG
MENU SELECT
7.LD CFG
MENU SELECT
9.SWITCH SLAVE
MENU SELECT
8.INFORMATION
Change Entry Point
Change Selection
Accept/Save Selection
Exit to Menu 0
VID MODE CFG
>VID01=>RGBLD_m
Select Video Input #.
Select Video Type.
AUD LEVEL CFG
>AUD01=>+00dB
Select Audio Input #.
Select dB Level.
HOST BAUDRATE
>9600
Select Baud rate for
Communication with Host.
RGB DELAY
>0.5 SECONDS
Select Time delay for
switching RGB after Sync.
SLAVE CFG
>SW 6-MX
Select type of switching
device used as a Slave
(or None).
LD SYNC CFG
>H/HVOUT=>CSYNC
Select type of Sync output.
Select Serrations:
Present or Remove
Display System 4 Information:
Projector type
Prj baud Rate
Host Baud Rate...
Go to
Menu 0
HORIZ. SHIFT
00
CONTRAST ADJ
00
COLOR ADJ
00
TINT ADJ
00
DETAIL ADJ
Level 1 OF 4
Not on System 4C
Press H SHIFT to Exit
Press CONT to Exit
Press COLOR to Exit
Press TINT to Exit
Press DETAIL to Exit
System 4
NE
Series LCD Menus
After 2-3 second delay
Turn VGA Mode (for LD only) and/or
Split Screen Mode On/Off
Select Slave Channels,
Chl 4 thru highest available
Displayed information
depends upon video type,
audio level and breakaway
setting.
Active only with VID
or YC type input. Go to
Menu 9
SYSTEM 4LQ NE
EXTRON V4.11 * *4LQ NE menus will not appear exactly as
shown here, i.e. LQ will replace LD, etc.
*Only if configured
as a Slave switcher