Extron Electronics PVS 204SA User Guide - Manual (Page 16)

PVS 204SA Switcher • Installation 2-4
Installation
PRELIMINAR
Y
Rear Panel Features and Cabling
L R
AUX/MIX IN
1B
1A
I
N
P
U
T
S
O
U
T
P
U
T
S
2B
2A
4
3
RS-232 MLC/IR
DC VOL
4/8
Ohms
AMPLIFIED OUTPUTS
VOL/MUTE
Tx
A B C
Rx IR 12V
10V
POWER
12V
3A MAX
US
LISTED 17TT
AUDIO/VIDEO
APPARATUS ®
RGB VIDEO RGB
VIDEO
STEREO ON
DUAL
MONO
HIGH
PASS
FILTER
OFF
ON
1A 3 2A 1A 3 2A
1B 4 2B
2
7 5
4
9 8
10
1
3
6
Figure 2-2 — Features of the PVS 204SA Switcher rear panel
Power connection
a
DC power connector — Attach the supplied male captive screw connector to
the cord of the included power supply as shown in figure 2-3.
Power Supply
Output Cord
Captive Screw
Connector
SECTION A–A
Ridges
Smooth
A A
Tie Wrap
3
16 (5 mm)
"
Figure 2-3 — Wiring the orange captive screw power connector
When all other cables have been connected, plug the captive screw connector
into the 2-pole female connector ( a ) to connect the switcher to the 12 VDC
power source. The front panel power LED ( ) lights while the PVS is
receiving power.
N Use only the supplied 12 V power supply for this switcher.
A/V input connections
b
B RGB video and audio inputs (“RGB”) — Each RGB input requires
the use of two twisted pair cables. Using the TP cables, connect one
or two high resolution computer video and audio sources via PVT
transmitters to these four RJ-45 female connectors.
C The PoleVault signal transmission method is specific for
PVS 204SA switchers working with PVT transmitters.
DO NOT connect to an MTP system.
DO NOT connect to an Ethernet/LAN or data transmission system.
N The PVS 204SA can receive signals from PVT transmitters located up to
100 feet (30 m) away. The optimum distance is between 50 (15 m) and
75 feet (23 m). The minimum distance is 15 feet (5 m).
1B
1A
RGB
I
N
P
U
T
S