Extron Electronics PA 300 - Manual (Page 16)

PA 300 Peaking Amplifier • Installation and Operation
Installation and Operation, cont’d
2-8
Cabling
The PA 300 is specifically designed for long cable run
applications. For best results, install the amplifier close to the
signal source to drive a long cable to the display.
The inputs of the PA 300 are BNC connectors. If the signal
source uses a 15-pin HD connector, use an Extron SYM BNCM
cable (Extron part #26-533-xx) to make the connection. See the
illustration below.
RGBHV
RGBS
RGsB,
RsGsBs,
Component
S-Video
Composite
G B H/V V
R G B V
R
G B H/V V
G B R H/V V
G B
R
H/V V
R
H/V
RGBHV
VGA
N For component and S-video connections G is luma (Y)
To make input and output connections to other devices, do the
following:
1.
Turn off the PC and the local monitor.
2. Connect the output of the RGB source to the PA 300 input.
3. Connect the PA 300 output to the RGB display device.
4. Turn on the source and display devices, then the PA 300.
5. Adjust the front panel potentiometers to achieve the
optimal image quality for your display. See chapter 3,
"Adjusting the Display", for detailed instructions.