Extron Electronics PA 300 User Manual

Page 13

PA 300 Peaking Amplifier • Installation and Operation

2-5

Remove two screws from one side of the unit. Retain the

screws for possible future use.

Attach one bracket to the side of the unit, using the

provided machine screws.

Repeat steps 1 and 2 on the other side of the unit.

Hold the PA 300 with the attached brackets against the

mounting location. On the mounting surface, mark the

location of the four bracket screw holes.

Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2.4 mm)

in diameter in the desk or table at the locations of the

mounting bracket screws. The holes should be drilled

from the underside or inside (concealed side) of the

furniture, where the amplifier will be located.

Insert #8 wood screws into the four pilot holes. Tighten

each screw into the mounting surface until slightly less

than 1/4" of the screw head protrudes.

Align the mounting screws with the slots in the brackets

and place the unit against the surface, with the screws

through the bracket slots.

Slide the unit slightly forward or back, then tighten all four

screws to secure it in place.