beautypg.com

Through-desk mounting, Through-desk mounting -6, Installation and operation, cont’d – Extron Electronics PA 300 User Manual

Page 14

background image

PA 300 Peaking Amplifier • Installation and Operation

Installation and Operation, cont’d

2-6

Through-desk mounting

Mount the PA 300 through a desk or table, using the optional

mounting kit (part #70-077-02), as illustrated below.

Through-desk mounting the PA 300

1

.

Install the brackets as shown above. Tighten the screws

only enough to allow sliding of the brackets.

2

.

Mark the opening through which the unit will be mounted

— approximately 1.8" by 8.9" (4.6 cm by 22.6 cm).

3

.

Cut out the material from the installation area.

4

.

Hold the unit, with the mounting brackets attached, under

the furniture where it will be secured. Mark where the

screws will attach the mounting bracket to the underside

of the furniture.

5

.

Drill pilot holes 1/4" (6.4 mm) deep and 3/32" (2.4 mm)

in diameter in the desk or table at the locations marked in

step 4.

6

.

Using the four provided wood screws, attach the brackets

to the mounting surface.

7

.

Slide the unit up and down or back and forth in the

mounting brackets until the face of the PA 300 is at the

desired height. Tighten the screws that secure the brackets

to the unit.