Extron Electronics MTP T 15HD A User Guide - Manual (Page 19)

MTP T 15HD A Architectural Series • Installation 13
Twisted Pair Cable Termination
Figure 14 details the recommended termination of twisted pair cables with RJ-45
connectors in accordance with the TIA/EIA T568A or TIA/EIA T568B wiring standards. You
can use either standard with CAT 5, 5e, or 6 cable, but ensure that you
use the same
standard on both ends of the cable.
RJ-45
Connector
Insert Twisted
Pair Wires
12345678
Pins:
Pin Signal
1 Red/V. sync +
2 Red/V. sync -
3
Green + 4
Blue/H. sync +
5
Blue/H. sync -
6
Green -
7
Mono audio +
8
Mono audio -
Wire color
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
Wire color
TIA/EIA T 568 A TIA/EIA T 568 B
White-orange
Orange
White-green
Blue
White-blue
Green
White-brown
Brown
NOTE: When using Enhanced Skew-Free
AV UTP cable, use the TIA/EIA T568A
standard only.
Figure 14. Twisted Pair Cable Termination Diagram
NOTES:
• RJ-45 termination with CAT 5, 5e, or 6 cable must comply with the TIA/EIA T568A
or TIA/EIA T568B wiring standards for all connections.
• RJ-45 termination with Skew-Free AV UTP cable must comply with TIA/EIA T568A
only.
• The audio data that is carried on wire pair 3 and 6 is incompatible with the Extron
TPX 88 A, which cannot switch the audio, output it locally, or break it away.
• Extron Enhanced Skew-Free AV cable is not recommended for
Ethernet or LAN applications. This cable is specially designed for compatibility with
Extron Twisted Pair products that are wired using the TIA/EIA T568A standard.
• The green, brown, and blue wire pairs of this cable have virtually identical
lengths and should be used to transmit the RGB signals.
• The orange wire pair of this cable has a different length and should not be used
to transmit the RGB signals.