Extron Electronics MTP T 15HD A User Guide - Manual (Page 13)

MTP T 15HD A Architectural Series • Installation 7
Final Installation
After testing and making any adjustments, turn off the power supply and carefully insert the
wall box or mud ring into the opening.
Attach it with nails or screws, leaving the front edge flush with the outer wall or furniture
surface (see figure 6).
NOTES:
• If attaching the wall box to wood, use four #8 or #10 screws or 10-penny nails. A
minimum of 0.5 inches (1.3 cm) of screw thread must penetrate the wood.
• If attaching the wall box to metal studs or furniture, use four #8 or #10
self-tapping sheet metal screws or machine bolts with matching nuts.
Installation
Cable
Cable
Clamp
Wall Stud
Screws
or Nails
Wall Stud
Installation
Cable
Cable
Clamp
Screws
or Nails
Figure 6. Installing the Wall Box
• If installing an MTP T 15HD A WM, mount the faceplate directly to the box or mud ring.
• If installing an MTP T 15HD A D, mount it directly to the wall box, then attach the
Decora wall plate, as shown in figure 7, and restore the power supply.
PC INPU
T
AU DIO
Wall opening
is flush with
edge of box.
Wall Box
Decora
Faceplate
MTP T 15HD A D
Figure 7. Mounting the MTP T 15HD A D