Extron Electronics IN1502 Setup Guide - Manual (Page 8)

1-2
Refer also to the IN1502 User’s Manual at www.extron.com.
About this Guide
This setup guide describes how to quickly install, configure, and
operate the Extron IN1502 digital two input video scaler and
how to operate the optional IR 901 infrared remote control.
Throughout this guide the terms "IN1502", "video scaler", and
"scaler" are used interchangeably to refer to the IN1502 product.
Options and accessories
IN1502 optional equipment includes:
I • R 901 remote control — Extron’s IR 901 (part #70-152-01)
is an infrared remote control which replicates all of the
front panel controls of the IN1502 except the Menu and
Next buttons.
R
• ack shelf mounting kit — The 1U high, half rack width
IN1502 can be rack mounted using the universal rack shelf
mounting kit RSU 129 (part #60-190-01) or the basic rack
shelf mounting kit RSB 129 (part #60-604-01).
A
• ccessories — Refer to the Appendix, "Reference, Parts
and Accessories".
Mounting the Scaler
Tabletop/desktop placement
For tabletop or desktop placement only, install the self-adhesive
rubber feet/pads (provided) on the four corners of the bottom of
the enclosure.
Rack mounting
N For Underwriters Laboratories (UL) guidelines pertaining
to the safe installation of the IN1502 in a rack, see the
IN1502 User's Manual located on the included CD ROM
or at www.extron.com.
If feet were installed on the bottom of the IN1502, remove them.
Place the IN1502 on one half of the 1U (one unit high, one unit
wide) RSU 129 rack shelf (part #60-190-01). Refer to the
illustration for rack mounting the IN1502.
IN1502 • Introduction
Introduction and Installation