Extron Electronics IN1502 Setup Guide - Manual (Page 13)

Refer also to the IN1502 User’s Manual at www.extron.com.
Menus, Configuration, and Adjustments
Scaler configuration and adjustments are done using the front
panel controls and menus displayed on the LCD screen, or by
using the Simple Instuction Set (SIS ™ ) commands via the RS-232
port. This setup guide provides installation and operating
instructions using the front panel. Further details on software
control can be found in the IN1502 User's Manual located on the
included CD-ROM and at www.extron.com.
Menu overview
After the initial power up sequence, and when no adjustments
are being made, the default display appears on the LCD screen.
The screen cycles between the active input number and video
format, and the output resolution and rate, as shown in the
flowchart below.
Power
on
INPUT 1
CMPOSITE
EXTRON
IN1502
2 sec.
2 sec.
60-726-1
FW v.1.00
2 sec.
INPUT 1
CMPOSITE
1024 x 768
@60
NO
SIGNAL
or
2 sec.
2 sec.
Default Display Cycle
Power up
Sequence
Default menus
N The "No Signal" default display occurs if there is no signal
present at the currently selected input.
N From any menu or submenu, after ten seconds of inactivity
the IN1502 saves all adjustments and switches to the
default display cycle.
IN1502 • Front Panel Operation 2-3