Extron Electronics FOXBOX Tx_Rx HDMI User Guide - Manual (Page 37)

Video Bit Depth area
NOTE: The Video Bit Depth area radio buttons are available only if
you are connected to the receiver.
The Video Bit Depth radio buttons allow you to force the bit depth to 8 bits or to set it to
auto.
Advanced tab functions
Click the Advanced tab to access the functions described below.
NOTE: The Advanced functions are available only if you are connected to the receiver.
Advanced Configuration area
Link 2 and Daisy Chain radio buttons —
Select among the Enable Link 2,
Disable Link 2, and
Enable Daisy Chain radio buttons to
define the function of the receiver Tx LC
connector; either:
• Routing RS-232 over fiber to the transmitter
• No function
• Routing the signal received on the Rx LC connector to the next receiver in a daisy chain.
NOTE: The disable return link function is primarily used and recommended when the
transmitting device is a FOX 500 DA6 and the receiver is connected to any of
outputs 2 through 6 on the FOX DA.
Auto Memory radio buttons — Select the Auto Memory radio button to automatically
apply saved position settings when the sensed input resolution changes.
Test Patterns drop box — Select one of three built-in test patterns; Colorbars,
Grayscale, and Alternating Pixels; as necessary to help adjust the color,
brightness/contrast, and focus of the display. Select Off to output the video that is input to
the transmitter.
NOTE: You must have a video input connected, the transmitter-Tx-to-receiver-Rx fiber
cable connected, and the receiver must not be in daisy-chain mode for the
receiver to output a selected test pattern.
The test pattern turns off if the input signal rate is changed or disconnected or if
power is removed.
FOXBOX Tx/Rx HDMI • Remote Control 31