Starting the program – Extron Electronics FOXBOX Tx_Rx HDMI User Guide User Manual
Page 33
Starting the Program
Start the Extron FOX Extenders program as follows:
1.
Click Start > Programs > Extron Electronics > FOX Extenders
Control Program > FOX Extenders.
The Communication Setup window appears (see figure 15).
Figure 15.
Communication Setup Window
2.
Select the Com port to which your transmitter or receiver is connected. Click OK. The
FOX Extenders Control Program window appears (see figure 16).
Figure 16.
FOX Extenders Control Program Window
NOTES:
•
Figure 16 is an amalgam of program displays. Some controls and displays
are available when connected to the transmitter only and some when
connected to the receiver only. These functions are identified in the
descriptions that follow.
• Only one fiber optic cable, transmitter-Tx-to-receiver-Rx, is required for
serial command transmission. But, if you connect only one fiber optic
cable, the transmitter will not receive reports from the controlled device.
For the transmitter to receive responses from the controlled device,
you must install two fiber optic cables and leave link 2 enabled (via an
to the receiver or using the
).
FOXBOX Tx/Rx HDMI • Remote Control
27