Extron Electronics FOX T UWP 302 User Guide - Manual (Page 46)

Installing Firmware with Firmware Loader
1. Open Firmware Loader and establish a connection between the computer and the
device. The Add Device... window opens.
Figure 38. Add Device... Window
2. Select FOX T UWP 302 from the Device Name drop-down list.
3. Select the method of connection from the Connection Method drop-down list.
4. Depending on the connection method, additional options appear. Make the appropriate
selections for the current connection method.
5. Click the Connect button.
6. Click the Browse button in the New File Firmware (Optional) section.
7. On the Open window, navigate to the new firmware file, which has an .S19 extension,
and click the
Open button.
ATTENTION: Valid firmware files must have the file extension .S19. A file with
any other extension is not a firmware upgrade for this device and could cause the
device to stop functioning.
8. Click Add . The Add Device... window closes and the device and firmware are listed in
the Firmware Loader main window.
9. Click Begin to start the upload process.
10. Close Firmware Loader when the Remaining Time field shows 00.00.00 , the
Progress column shows 100% , and the Status field shows completed .
NOTE: See Simple Instruction Set Control on page 13 for reset information.
FOX T UWP 302 Wallplate Transmitter • Reference Information 40