Extron Electronics FOX T UWP 302 User Guide User Manual
Page 24
Command
ASCII Command
(Host to Device)
Response
(Device to Host)
Additional Description
Advanced Configuration
Input sync detection
View input sync detection
E
1LS
}
xxx.x,xxx.x
]
Shows horizontal frequency in kHz
and vertical frequency in Hz.
000.0,000.0
if no signal.
Input video format (VGA only)
Set input video format
1*
X1%
\
Typ1*
X1%]
Sets input 1 to format
X1%
.
View input video format
1\
X1%]
View video format of input 1.
Plus mode transmission
Disable Plus mode
transmission
81*0#
Plus0
]
Disable Plus mode transmission.
Enable Plus mode
transmission
81*1#
Plus1
]
Enable Plus mode transmission
(default).
View Plus mode
transmission
81#
X%]
View Plus mode transmission
setting.
HDCP authorized device (HDMI input only)
HDCP authorized device on
E
E2*1HDCP
}
HdcpE2*1
]
HDCP authorized device on for
input 2 (default).
HDCP authorized device off
E
E2*0HDCP
}
HdcpE2*0
]
HDCP authorization off for input 2.
Query HDCP authorized
device status
E
E2HDCP
}
X^]
View the HDCP authorization
status.
HDCP status (HDMI input only)
Query HDCP status
E
I2HDCP
}
X1#]
Query the HDCP status of the
current input.
NOTE:
X%
= Enable or disable
0
= off or disabled
1
= on or enabled
X^
= HDCP authorization
0
= HDCP authorization off
1
= HDCP authorization on (default)
X1#
= HDCP status
0
= no source detected
1
= source detected with HDCP
2
= source detected but no HDCP is present
X1%
= Input video format
0
= auto detect (default)
1
= RGB (full range)
2
= YUV
FOX T UWP 302 Wallplate Transmitter • SIS Configuration and Control
18