Extron Electronics FOX T UWP 302 User Guide - Manual (Page 22)

Command and Response Tables for SIS Commands
Command ASCII Command
(Host to Device)
Response
(Device to Host)
Additional Description
Input Switching
Input selection
Video input select X1! ! In X1!• ALL ] Select input X1! .
View video input ! X1!] View currently selected source.
NOTE: The FOX T UWP 302 saves the last input selection when cycling power.
Auto switch mode
Disable auto switch mode E 0AUSW } Ausw0 ] Manual input switching only.
Set priority to the highest
active input E 1AUSW } Ausw1 ] Gives priority to the highest
numbered active input (default).
Set priority to the lowest
active input E
2AUSW
}
Ausw2
] Gives priority to the lowest
numbered active input.
View auto switch mode
setting E
AUSW
} X1@] View current setting.
NOTE: This command can be entered only via RS-232 or USB. The settings will only reset back to (off) once
setting is changed, or when unit is reset.
Audio Configuration
Audio gain and attenuation
NOTE: Gain and attenuation are case-sensitive.
Set gain X&
G Aud
X(] Set gain to X( .
Set attenuation X* g Aud X(] Set attenuation to X( .
Increment gain or
attenuation +G or +g Aud X(] Audio level is X( .
Decrement gain or
attenuation -G or -g Aud
X(] Audio level is X( .
View audio level G or g X(] View current audio level.
Audio input selection
Set audio input format E
I
X1!
*
X2%
AFMT
}
AfmtI
X1!
*
X2%]
View input audio format E
I
X1!
AFMT
} X2%]
NOTE: X& = Audio gain 0 to 10 (in dB)
X* = Audio attenuation –18 to 0 (in dB)
X( = Audio level –18 to + 10 (in dB)
X1! = Input selection 1 = VGA
2 = HDMI
X1@ = Auto switch mode 0 = disable
1 = gives priority to the highest numbered active input
(default)
2 = gives priority to the lowest numbered active input
X2% = Audio input format 0 = auto (default)
1 = embedded digital
2 = analog
FOX T UWP 302 Wallplate Transmitter • SIS Configuration and Control 16