Extron Electronics FOX T UWP 302 User Guide - Manual (Page 25)

Command ASCII Command
(Host to Device)
Response
(Device to Host)
Additional Description
Device name
NOTE: No blank or space characters are permitted. The first character must be a letter. The last character
cannot be a minus or hyphen.
Set unit name EX1^
CN
}
Ipn •X1^] Set device name.
Set unit name to factory default E•
CN
}
Ipn •X1&] Set device to default.
View unit name E
CN
} X1^] View device name.
Information requests
General information I 1Lnk
X%•
2Lnk
X%•
Vid
X%•
Aud
X%•X1)•
TX
]
Query part number N 60-1232-xx ]
Query firmware version Q x.xx ]
Query firmware build *Q x.xx.xxxx ]
Query all firmware version 0Q x.xx-x.xx ]
Query updated FPGA version 35Q x.xx ] View the updated loaded
FPGA version.
Status request
View fiber link 1 status 1S X%]
View fiber link 2 status 2S X%]
View input video status 3S X%X%] View the on or off status
of input 1 and 2.
View input audio status 4S X%]
Request all signal status 5S SigI
X%X%•
SigO- • 2HdcpI
X%•
HdcpO-
]
Request HDMI signal status 6S SigI
X%•
SigO-
]
Request HDCP status 7S 2HdcpI X%• HdcpO- ]
NOTE: X% = Enable or disable 0 = off or not detected
1 = on or detected
X^ = HDCP authorization 0 = HDCP authorization off
1 = HDCP authorization on (default)
X1) = SFP module type SM = singlemode
MM = multimode
X1# = HDCP status 0 = no source detected
1 = source detected with HDCP
2 = source detected but no HDCP is present
X1^ = Unit name Text string up to 24 characters ( A - Z , 0 - 9 , - )
X1& = Extron device name FOX-T-UWP-302
FOX T UWP 302 Wallplate Transmitter • SIS Configuration and Control 19