Using the help system, Button label generator program, E 8 for sample button icons – Extron Electronics FOX SW8 User Guide User Manual
Page 24: Button label generation program
FOX SW8 • Remote Control
18
NOTES:
•
When downloaded from the Extron website, the firmware is placed in a
subfolder of
C:\Program Files\Extron\Firmware
.
•
Valid firmware files must have the file extension .S19. A file with any other
extension is not a firmware upgrade.
•
The original factory-installed firmware is permanently available on the switcher.
If the attempted firmware upload fails for any reason, the switcher reverts to
the factory-installed firmware.
12.
In the Firmware Loader window, click
Begin
(see figure 18).
The
Total
Progress
and
Progress
status bars show the upload progress. The firmware
upload may take several minutes. Once the status bars have progressed from
0%
to
100%
, and Status is listed as
Completed
, the firmware loader utility resets the switcher.
12
Figure 18.
Firmware Loader Screen
13.
Click
Exit
to close the Firmware Loader.
Using the Help System
For information about program features, you can access the help program in either of the
following ways:
From within the switcher control program, select
Help
>
Contents
on the task bar.
From within the switcher control program, press the
Button Label Generator Program
The Button Label Generator software creates labels that you can place in the translucent
covers of the input selection buttons. You can create labels with names, alphanumeric
characters, or even color bitmaps for easy and intuitive input and output selection.
on page 20 documents the procedure for removing and replacing the translucent
covers.
The Extron Button Label Generator is available on the Extron website,
www.extron.com
,
under the
Download
tab. Click the
Software
link (see figure 19), and download and install
the program.
Figure 19.
Extron Download Center