Extron Electronics FOX SW8 User Guide - Manual (Page 16)

FOX SW8 • Remote Control 10
Error Responses
When the unit receives a valid SIS command, it executes the command and sends a
response to the host device. If the unit is unable to execute the command because the
command is invalid or it contains invalid parameters, the unit returns an error response to
the host. The error response codes are:
E10 — Invalid command
E12 — Invalid output number
E13 — Invalid range
E22 — Busy
Timeout
Pauses of 10 seconds or longer between command ASCII characters result in a timeout.
The command operation is aborted with no other indication.
Using the Command and Response Table
The Command and Response Table for SIS Commands is on page 11. Commands in
the table are NOT case sensitive. The ASCII to HEX conversion table, below, is for use with
the command and response table.
ASCII to Hex Conversion Table
•
Space
Symbol Definitions
Symbols (variables), defined below, are used in the command and response table. The
symbols represent variables in the command and response table fields.
] = Carriage return/line feed
} = Carriage return (no line feed)
E = key (hex 1B)
•
= Space (hard) character
W = Can be used interchangeably with the E character
| = Can be used interchangeably with the } character
X! = Input 00 through 08 ( 00 = no input)
X@ = Mute/front panel lock status 0 = off (unmuted/unlocked) 1 = on (muted/locked)
X# = Transceiver module status 0 = no module installed
1 = multimode 2 = singlemode
X$ = Firmware version v.vv
X% = Transceiver module status 0 = no light input 1 = light input
X^ = Temperature nnn F = whole degree Fahrenheit
X& = Input reclocker rate 00 = Bypass (no reclocking) 02 = 2.125 Gbps
01 = 1.25 Gbps 03 = 4.25 Gbps ( default)
X* = Name Up to 24 upper- and lower-case alphanumeric characters. Hyphen characters
are valid, blank and space characters are invalid. The first character must be a
letter. The last character may not be a hyphen.