Extron Electronics DVI DL 201 Tx_Rx User Guide - Manual (Page 10)

DVI DL 201 Tx Rear Panel
The illustration below shows the rear panel features of the DVI DL 201 Tx.
12V
0.4A MAX
POWER
DVI-D INPUT LOCAL OUTPUT
OUTPUTS
DO NOT CONNECT
OUTPUTS TO LAN
1 2 3
SN XXXXXXXX E XXXXX 00/00 DVI DL TX
STORE
EDID
Tx Rx
CONTROL
PASS THRU
ON
1 2 3
ON
OFF
DEF
AU
LT
EDID
EDID MINDER REMOTE DDC
2 3 4 5 6 7 8
DVI DL 201 Tx
Figure 3. DVI DL 201 Tx Rear Panel Features
b
Power input — The 12 VDC power supply (provided) connects to this two-pole,
3.5 mm captive screw connector.
c
DVI-D input — One female DVI-I connector accepts a dual-link DVI-D input from the
source device.
d
Local monitor output — One female DVI-I connector provides a dual-link DVI-D
output to the local monitor.
e
EDID Minder Store switch and LED — When depressed, the transmitter reads and
stores the EDID information from the local monitor. The LED gives the status of this
process.
f
DDC route switches — Three DIP switches allow the unit to be configured to use the
EDID Minder or route the DDC directly to the display.
g
Control signal pass-through — A three-pole, 3.5 mm captive screw connector
inputs pass-through RS-232 (two-way) or IR signals (one-way).
h
Twisted pair outputs — Three RJ-45 jacks are used for transmitting DVI video,
remote power, and communications/control signals.
NOTES: The DVI DL 201 transmits high frequency signals via these TP outputs.
Connections between the transmitter and receiver must be point to point.
It is recommended that there should be no couplers, adapter, or patch
panels between the transmitter and receiver units.
Do not use skew-free cable. Extron strongly recommends DTP26 cable,
especially when using high resolutions such as 1920x1200, 1600x1200,
or 2560x1600. DTP26 cable is available as non-plenum (part number
22-214-03) or plenum (part number 22-215-03).
DVI DL 201 Tx/Rx • Panels and Cabling 4