Extron Electronics DVI 201 User Guide - Manual (Page 8)

Features
Transmits single link DVI-D signals over two CAT 5/5e/6 cables — Standard twisted
pair cables provide an economical, easily installed cable solution.
Local monitor output (DVI 201 Tx [non-Decora] only) —
The DVI 201 Tx transmitter features a DVI-D output for connection to a local monitor.
Supports DDC and HDCP copy protection transmission — The Tx/Rx pair fully
supports long distance transmission of the DDC and HDCP signals.
Control communications pass-through — Bidirectional RS-232 or IR control signals
can be transmitted alongside the DVI signal, so that the remote display can be controlled
without the need for additional cabling.
Audio routing — The DVI 201 A D Tx/Rx also routes unbalanced stereo audio when both
units are the Decora form factor.
Supports CEC signal transmission
1-inch high, quarter rack width, metal enclosures (DVI 201 Tx and DVI 201 Rx
[non-Decora] only)— With low profile enclosures, both transmitter models and both
receiver models can be discreetly installed in locations such as behind a plasma or LCD
flat-panel display.
Wall-mountable enclosures (DVI 201 A D Tx and DVI 201 A D Rx [Decora] only)
External 100 VAC to 240 VAC, 50-60 Hz, international power supply
(part #70-055-01) — Included with units sold as a paired system and with transmitters
Remote powering of transmitter or receiver — Only one power supply is necessary to
power both devices.
DVI 201 • Introduction 4