Extron Electronics DVI 201 User Guide - Manual (Page 19)

Final installation
After testing and making any adjustments, do the following:
1. At the power outlet, unplug the power supply.
NOTE: One power supply can power both the transmitter and the receiver, so only
one unit needs a power supply.
2. Mount the transmitter or receiver into the wall box, and attach the supplied Decora
faceplate to the unit, as shown in figure 12.
Wall opening
is flush with
edge of box.
Wall Box
Decora
Faceplate
Extron
DVI 201 A D
DVI
AU DIO IN
INPU T
Tx
Rx
RS-232
PAS S TH RU
Figure 12. Mounting the Transmitter or Receiver
3. At the power outlet, reconnect the power supply. This powers up both units.
DVI 201 • Installation and Operation 15