Item – Extron Electronics DVI 201 User Guide User Manual
Page 24
h
Receiver input ports — Connect one end of the two separate TP cables from the
transmitter output connectors (
on page 17) to these RJ-45 female connectors.
CAUTION: Do not connect this device to a computer data or telecommunications
network.
Connect the free ends of the same TP cables from the receiver to the female Output
RJ-45 connectors (
on page 17) on the transmitter.
to properly wire the RJ-45 connectors.
NOTES: • In order to fit in the junction box, the TP cables and RJ-45 connectors
should not have a boot installed.
• Extron recommends 28AWG to 24AWG TP cable for the RJ-45
connectors.
• For resolutions of 1600x1200, 1920x1200, and 1080p, Extron strongly
recommends DTP26 cable, or equivalent.
• Connect transmitter output 1 to receiver input 1. Connect transmitter
output 2 to receiver input 2.
• If necessary, test for proper cable connection (output 1 to input 1,
output 2 to input 2) as follows:
1. Plug both TP cables into the powered unit.
2. Momentarily connect either of the cables on the opposite end into
the “2” connector on the unpowered unit.
If the Power LED on the unpowered unit is lit, the connection is
correct.
If the Power LED on the unpowered unit is not lit, unplug the
connector on the unpowered end and connect the other cable to
the “2” connector.
i
DVI Output connector — Connect a DVI display for the transmitted direct digital
for pin assignments.
j
Audio Input connector (DVI 201 A D Rx [Decora] only) — Connect one end
of a 5-wire audio cable to this 3.5 mm, 5-pole direct insertion connector.
Connect the free end of the same cable to any compatibly wired audio source unit,
such as the output of a switcher or a DVI 201 A D Tx (Decora) transmitter (
on
page 18).
Figure 19 shows how to wire the captive screw audio connector. Insert the wires into
the appropriate openings in the direct insertion connector. Tighten the screws on the
side to fasten the wires.
Tip
Sleeve
Sleeve
Tip
Unbalanced Input
Balanced Input
Do not tin the wires!
Sleeve (s)
Tip
Tip
Ring
Ring
L
A
UDIO
OUTPUT
R
L
A
UDIO
OUTPUT
R
Figure 19.
Captive Screw Connector Wiring for Receiver Audio Input
k
DC power input connector — Plug the included external 12 VDC power supply
into either this 2-pole connector or the power input connector on the transmitter
(
to wire the connector.
DVI 201 • Installation and Operation
20