Extron Electronics Cable Retraction System Setup Guide - Manual (Page 8)

8
Cable Retraction System • Setup Guide (Continued)
Alternative Solution — Drop-in Installations
When installing the retraction system where under‑table access is limited, vertical or angular mounting is required.
See “
Getting Started — Determine Under-table Clearances ” on page 2 to be certain there is enough space for vertical
installation and “ Getting Started — Prepare the Enclosure ” on page 4 to determine the location of the retraction system in
the Cable Cubby enclosure.
The retraction system must be installed before dropping the enclosure into the
table.
1. For retrofit installations, remove the Cable Cubby enclosure from the
furniture before mounting the retraction system.
For new installations, follow the Cable Cubby enclosure preparation
instructions but do not mount the enclosure.
2. Install the retraction system in the enclosure following the installation
instructions (see “
Installation ” on page 6) and locking screw instructions
(see “ Locking Screw (Optional) ” above).
NOTE: Connect all cables before lowering the enclosure
into the cutout.
3. Once the retraction system is installed, lower the enclosure and retraction
system into the cutout ensuring that kinking or bending of the cables is
prevented.
4. After the enclosure has been dropped into the opening, lift it just enough to
allow the two screw clamps to be installed. It is not possible to adjust the
screw clamp for an exact fit and will take some trial and error to adjust it for
the tightest fit.
Screw Clamp
(both sides)
Locking Screw (Optional)
If the retraction system is mounted next to an unused location in the Cable
Cubby enclosure, a locking screw is provided to prevent the retractors from
rotating on the mounting bolt during operation.
If needed, tighten each locking screw to prevent movement of the retractor.
There is one locking screw for each retractor.
NOTE: Do not overtighten. The locking screw only needs to be
snug.
Tighten locking
screw (1 each).
Locking
Screw
Cable Retraction System • Locking Screw and Drop-in Installations