Extron Electronics Cable Retraction System Setup Guide - Manual (Page 3)

3
Product Category
Top View
Horizontal
Bracket
UNSWITCHED
100-240V/ 5AMAX
UNSWITCHED
USP HUB4 AA
P
AC
TIVITY
100-240V/ 5AMAX
All installations (Except Drop-In):
The retraction system can be mounted from below the Cable Cubby enclosure.
Horizontal Mounting: Be certain the horizontal mounting bracket can be fastened under the table or on a table support without
bending the pulley system or forcing it from perpendicular with the enclosure (see the Top View diagram below, left).
Vertical Mounting: Ensure the retraction system will hang freely without touching the floor and is not obstructed by anything
under the table. The standard system requires about 24 inches (61 cm) and the XL systems require about 30 inches (76.2 cm)
from the top of the furniture to clear the floor.
Angular Mounting (XL models only): For installations where the tabletop is less than 30 inches from the floor, the XL retractor
system is too long for vertical mounting and there may not be adequate under‑table clearance for horizontal mounting. An
additional mounting hole has been provided for these installations that allow the retractor system to install at an angle providing
extra floor clearance (see diagram below, right).
29.3"
(74.5 cm) 28.0"
(71.1 cm)
Floor
27.7"
(70.3 cm)
10.4"
(26.4 cm)
25
1.6"
(4.1 cm)
XL Models Vertical Clearance -
Angular and Vertical Mounting
For minimum table height
requirements of 28 inches
(71 cm) specified by ADA
Section 4.32.