Xylem MULTI 3400 MULTI-PARAMETER METERS - Manual (Page 45)

Multi 3400i Operation
45
As soon as all of the 500 storage locations are occupied, AutoStore is
terminated (Int 1 = OFF). If there are not enough storage locations
available for your measurements:
z Output and backup the data storage (see page 46) and
z clear the memory (see page 52).
Note
The AutoStore function is interrupted if you start other functions, e.g.
output the data storage. After the other function is finished, the Au-
toStore function is continued. By this, however, temporal gaps in the re-
cording of the measured values will occur.
Switching off AutoStore Switch AutoStore off by:
z setting the save interval (Int 1) to OFF, or
z switching the measuring instrument off and then on again.
6 Set the required ID number with <
▲> <▼>.
7 Confirm with .
The measuring instrument switches to the last active measur-
ing mode and start the measuring and saving procedure. Au-
toStore flashes on the display.
e r F
9 9 9
S
1
LoBat
Tref25
nLF
/ K %
RCL
Sal
°
AR
TP
C
M
m
% mg/l
cm
S/ cm
cm 1/
° F
ARng Cal Lin
Tref20
Sal TDS
mbar
O UpH
mV/pH
AutoCal DIN
AutoCal TEC
Time Baud
Day.Month No.
Year
1
Store Auto
Ident