Xylem MULTI 3400 MULTI-PARAMETER METERS - Manual (Page 41)

Multi 3400i Operation
41
4.5 Calibration intervals (Int 3, Int 4, Int 5)
For each measured variable, a time interval is stored. When it has ex-
pired, you will be reminded to calibrate. After a calibration interval has
expired, the probe symbol of the relevant measured variable flashes. It
is still possible to measure. By calibrating the relevant probe, the func-
tion is reset and the interval starts anew.
The following calibration intervals are set in the factory:
Setting the calibration
interval
You can change each of these intervals (1 ... 999 days):
Measured parameter Designation Default setting
pH/ORP Int 3 7 days
Dissolved oxygen Int 4 14 days
Conductivity Int 5 180 days
1 Switch off the measuring instrument.
2 Press the key and hold it down.
3 Press the key.
The display test appears briefly on the display. After this, the
measuring instrument automatically switches over to configu-
ration.
4 Press the key repeatedly, until Int 3 ... 5 to-
gether with the required measured variable (pH, O
2
or ) ap-
pears on the display. Example:
5 Set the required interval until the next calibration with <
▲>
<
▼>.
6 Confirm with .
7 Switch to the measuring mode with .
° C
1
TP
ARng
mg/l
LoBat
Baud
Day.Month No.
Ident Year
Sal
%
mbar
S
RCL AR
Store Auto
° F
1/cm
/ K %
TDS UpH Sal
mV/pH
S/ m
cm
cm M
Lin
Tref25 Tref20
nLF
AutoCal DIN
AutoCal TEC
4 1
t 4 n
O
1
d Time
Cal