Xylem inoLab 7310_7310P WASTEWATER pH METER - Manual (Page 49)

pH 7310 Data storage
ba75929e03 12/2011 49
automatic storage of measurement data (such as the display). By pressing any
key the energy saving mode is switched off again.
Terminating the
automatic storage
function prema-
turely
Proceed as follows to switch off the automatic storage function before the
adjusted storage duration has expired:
8.3 Measurement data storage
8.3.1 Editing the measured value storage
The contents of the manual or automatic measurement data storage can be
shown on the display and output to the interface.
Each of the measurement data storages has a function to erase the entire
contents.
Editing the data stor-
age
The storage is edited in the menu, Storage & config / Data storage. To open
the Storage & config menu, press the [Menu] key in the measured value
display.
Open the manual or automatic storage directly with the or key.
1. Press the key.
The following window appears.
2. Using <><>, select Yes and confirm with .
The meter switches to the measured value display.
The automatic storage function is terminated.
Stop automatic storage?
Yes
No
Warning
01.07.2011
08:00
Back
The settings are explained here using the manual storage as an
example. The same settings and functions are available for the
automatic storage.