Xylem inoLab 7310_7310P WASTEWATER pH METER - Manual (Page 38)

Settings pH 7310
38 ba75929e03 12/2011
7 Settings
7.1 Measurement settings
7.1.1 Changing the settings for pH measurements
The settings are made in the menu for calibration and measurement settings of
the pH/ORP measurement. To open the settings, display the required parame-
ter in the measured value display and press the /[menu] or key.
After completing the settings, switch to the measured value display with .
Default settings are printed in bold.
Menu item Possible set-
ting Description
Calibration
/Cali-
bration record
-
Displays the calibration record of
the last calibration.
Calibration /
Calibration data
storage
/Display
- Displays the calibration record.
Further options:

Scroll through the calibration
records with <><>.
 Output the displayed calibration
record to the interface with
/[USB output].
 Output all calibration records to
the interface with [USB
output]
.
 Quit the display with /
[Back]
or .
 Switch directly to the measured
value display with .
Calibration
/ Cali-
bration data stor-
age
/ Output to USB
-
Outputs the calibration records to
the interface.
Calibration / Serial
number (probe)
Entry of the serial number of the
connected sensor.
The serial number is output in the
calibration record.
 Change the content of the high-
lighted position with <><>.
 Go to the next position with
/[].
 When the serial number has
been completely entered, con-
firm with .