Xylem inoLab 7310_7310P WASTEWATER pH METER - Manual (Page 43)

pH 7310 Settings
ba75929e03 12/2011 43
7.3 Sensor-independent settings
7.3.1 System
To open the Storage & config menu, press the [Menu] key in the mea-
sured value display. After completing the settings, switch to the measured
value display with .
Default settings are printed in bold.
Resolution mV 0.1
1 Resolution of the mV display
Stability control On
Off Switches on or off the automatic stability
control during measurement (see sec-
tion Stability control (AutoRead) &
HOLD function, page 22 )
Reset -
Resets all sensor settings to the delivery
condition (see section 7.4.1 R
ESETTING
THE MEASUREMENT SETTINGS , page 44).
Menu item Possible set-
ting Description
System
/ General /
Language
Deutsch
English
(further)
Selects the menu language
System / General /
Beep
On
Off Switches on/off the beep on
keystroke
System
/ General /
Illumination
Auto
On
Off
Switches the display illumina-
tion on/off
System
/ General /
Contrast
0 ... 50 ... 100 %
Changing the display contrast
System / General /
Switchoff time
10 min ... 1h ...
24 h Adjusts the switch-off time
System / Interface /
Baud rate
1200, 2400,
4800, 9600,
19200 Baud rate of the data interface
System / Interface /
Output format
ASCII
CSV Output format for data trans-
mission (see section 9 T
RANS -
MITTING DATA (USB INTERFACE ),
page 52)
System / Interface /
Decimal separator
Dot (xx.x)
Comma (xx,x) Decimal separator
Menu item Possible
setting Description