YSI MIQ/Blue PS Set - Manual (Page 32)

Installation MIQ/Blue PS
3 - 22 ba76095e02 01/2013
Fig. 3-16 Line power connection.
Note
The complete assignment of the terminal strip is shown in section 3.7.
Warning
No free wires must be allowed to project into the enclosure. Oth-
erwise there is the danger of short circuits that can cause a fire.
Always cut off any wires that are not in use as closely as possible
to the cable gland.
8 Connect wires 1 and 2 to the terminal strip. Make sure that the
cable assignment agrees with the specification on the terminal
label under the terminal strip.
9 Tighten the coupling ring (pos. 3).
10 Close the enclosure.
3
Terminal
labeling:
X11 X10
24V DC
EINGANG
INPUT
POWER
+ -