YSI MIQ/Blue PS Set - Manual (Page 25)

MIQ/Blue PS Installation
3 - 15 ba76095e02 01/2013
General installation
instructions
Observe the following points when attaching connecting wires to the
terminal strip:
 Shorten all the wires to be used to the length required for the instal-
lation
 Always fit all the ends of the wires with wire end sleeves before con-
necting them to the terminal strip
 Any wires that are not used and project into the enclosure must be
cut off as closely as possible to the cable gland.
 In each of the remaining free openings, screw in a small cable gland
with sealing ring and close them with a blind plug.
Warning
No free wires must be allowed to project into the enclosure. Oth-
erwise, there is a danger that areas safe to contact could come
into contact with dangerous voltages. This could result in life
threatening electric shock when working with the IQ S
ENSOR N ET .
Always cut off any wires that are not in use as closely as possible
to the cable gland.