YSI NiCaVis 705 IQ - Manual (Page 17)

NiCaVis 705 IQ
Commissioning
3 - 7 ba75950e01 03/2013
3.4 Initial commissioning
3.4.1 General information
CAUTION
Never look into the measuring window or put objects into the measur-
ing window during operation! The emitted UV radiation can damage the
eyes!
In the case of authorized use, inadvertent eye contact with the light
beam is not possible.
Measuring location The sensor is prepared for operation in the outlet of the waste water
treatment plant and calibrated in the factory. The sensor is immediately
ready to measure.
How to adjust the settings is described in the following section (section
3.4.3).
User calibration after initial
commissioning
On the basis of a reference measurement ("laboratory value"), check
whether the default settings deliver sufficiently accurate measured
values or whether you want to carry out a user calibration (see section
4.3 C
ALIBRATION
).