Xylem 19 001 300 R2 Silent Storm VFD Pumping System OMRON Touch Screen Display Manual - Manual (Page 33)

© 2013 Flowtronex
How Do I? 29
2.1 Set Clock
You can access the Set Clock screen by pressing the Set Clock touch key on the Main Menu .
· Press the Set Clock touch key on the Main Menu to open the Set Clock screen and set the time
on the PLC.
· Tap on any of the value fields to open the pop-over calculator/keypad and change the values for
Day and Time. (See also, Calculator/Keypad .).
· Press the System Status key to return to the Main Menu. (See also, System Status .)
· Press the Back key to return to the Main Menu. (See also, Main Menu .)
2.2 Reset Alarms
Use the Reset button on the enclosure door to reset faults and alarms.
Note:
The Master Control Interface (MCI) only displays the status of alarms—it does not
clear them.
Keep in mind, the Low Discharge Pressure switch in the door can be placed in Override, allowing the
pump station to run, build pressure, and remove the Low Discharge Pressure Fault. In the case of a
VFD fault, the fault must be cleared by cycling the power off and on.
If a fault or alarm does not reset, the fault is still present. Further troubleshooting and repair must be
performed. Contact Flowtronex® Product Support for further instructions.