Acer Altos G520 User Manual
Page 126
4 BIOS setup
116
FDC Failure
Error occurred trying to access diskette drive con-
troller.
HDC Failure
Error occurred trying to access hard disk controller.
Checking NVRAM.....
NVRAM is being checked to see if it is valid.
Update OK!
NVRAM was invalid and has been updated.
Updated Failed
NVRAM was invalid but was unable to be updated.
Keyboard Error
Error in the keyboard connection. Make sure key-
board is connected properly.
KB/Interface Error
Keyboard interface test failed.
Memory Size
Decreased
Memory size has decreased since the last boot. If no
memory was removed, then memory may be bad.
Memory Size
Increased
Memory size has increased since the last boot. If no
memory was added, there may be a problem with
the system.
Memory Size
Changed
Memory size has changed since the last boot. If no
memory was added or removed, then memory may
be bad.
No Boot Device
Available
System did not find a device to boot.
Off Board Parity
Error
A parity error occurred on an off-board card. This
error is followed by an address.
On Board Parity Error
A parity error occurred in onboard memory. This
error is followed by an address.
Parity Error
A parity error occurred in onboard memory at an
unknown address.
NVRAM / CMOS /
PASSWORD cleared
by Jumper
NVRAM, CMOS, and passwords have been cleared.
The system should be powered down and the
jumper removed.
CMOS is ignored and NVRAM is cleared. User must
enter Setup.
Error Message
Explanation
BB!H631!.!FO/cppl!!Qbhf!227!!Uvftebz-!Bvhvtu!28-!3115!!5;13!QN