Acer Veriton N2620G - Manual (Page 59)

Echo Control Panel | 59
VMware View
The VMware View client allows you to connect to a VMware server,
which in turn, provides the end-user with their own virtual desktop
session. The following section describes the basic steps for configuring
the View Client in WES.

Server Address-Enter the Hostname or IP address of your
VMware View Broker.

Credentials-Specify the User Name and Password of a user
account you wish to log on as.

Domain-Specifies the domain to log on to.

Desktop Name-If the user of this thin client should always connect
to the same desktop, then you may consider entering its name into
this field. If you choose to leave the field empty, then the user will
be prompted to select an available desktop at the time they connect
to the VMware View server.

Protocol: Choose whether to connect to your VMware View server
using the RDP or PCOIP protocol.

Desktop Layout: Choose the desktop option that best suits your
display setup.

Autostart:-Enable this checkbox to automatically launch this
session after the thin client completes its boot procedure.