Acer Veriton N2620G - Manual (Page 51)

Echo Control Panel | 51
Diagnostics
If you are experiencing difficulty connecting to servers on certain
segments of your LAN, then you may want to use the ping command to
verify you are reaching specific servers and/or gateways on the subnet in
question. To use ping:
1. Select the Diagnostics tab from the Network Tools window.
2. In the Host Address field, type in the IP address or website you
want to test against and then press the Ping button.
3. If there is an error in the delivery to the destination, the ping
command displays an error message. Otherwise, replies will
continuously display for each packet successfully sent and
received.
4. Press the Stop button to terminate the ping loop.
Connections
Adding New Connections
6 Open the Echo Control Panel.
7 Click the icon you wish to create; it is listed under the
Connections bar, on the left-hand side of the Echo Control
Panel.
8 The main window will split into two separate frames. The top
frame will list all existing connections for this particular type or
protocol. To add a new connection, click the plus [+] button.
9 You will be prompted to enter a name for this connection. Enter a
name for this connection and press the OK button to continue.