AVSL 153.118 MMD-PC1 PC KIT - Manual (Page 6)

P ramming Manual Programming Manual
2.4: Remote control operation
Item Key Description
1
ON/OFF
Power On / Off. If there is no file in 01 to 99, it will run file 00.If there is file in 01 to
99, it will display the last saved file.
2 PROG Enter the Edit Program Mode. Select 01 to 99 to enter message.
Use for edit or reset password
3 CPW
Use PREV and NEXT to select (a) to (d)(a) UNUSE PASS Turn off password
security.(b) USE PASS Turn on password security(c) RES PASS Reset to
factory default password “000”.(d) CHANGE PASS Change to new password (see
4
MET
To select the display modes, totally up to 24 different modes. Note: Press PREV
and NEXT to select (1) to (24) methods. See Appendix A.
To type a special
characters or symbol
Press PREV or NEXT to
move from mode to mode
Use SPA to insert a blank
space between characters
-Press PROG to enter into text
editing mode
- Type in your password
(default=”000”)
then press ENTER
-Type in:”OPEN: 01”.
then press ENTER
-… … start programming
Hold down ALT and
then press ON/OFF to
turn the sign of and on
Press RUN to exit
programming mode
Point the end of the remote control
at the front of your sign
Hold down ALT and then
press any key to select
character or symbol above
selected key
In text editing mode:
Hold down ALT and
then
press GRA to put the sign into
one of these modes:
(Use PREV or NEXT to
move from mode to
mode and ENT to
select a mode.)
- GET GRAPH – for getting
GRAPH A - P
- MAKE GRAPH – for
making NUMBER A –H
- EDIT GRAPH – for editing
NUMBER A-P
－
Page6
-